Please contact your local distributor for information on ordering

The Matex Fluid Injector is AIR operated and TIME activated. It is completely self-contained and easy to install. The Matex Fluid Injector can be used to inject a wide range of different products such as Tri-Lube, RDO-302 ES, Hole Control, Vibra-Stop, Liquid polymers, Foam etc.If injecting foam, a Matex soluble lubricant must be used to avoid rust that could be caused from the foam.

The pump is designed to deliver a measured amount of product each injection to ensure a proper mixture. The pump has been designed with only one moving part to ensure low maintenance.

The timer assembly is available in a range of different voltages and is designed to measure the exact amount of injection necessary to deliver the amount of product desired. The timer has a setting dial on the face of the timer for the ease of increasing or decreasing the amount of product necessary, or timer can be pre-set for lubricating at a set rate.

All parts are warrantied of manufacturers defects for a period of one year of normal operation using only Matex products. For warranty and return policy information please contact brianc@controlchemical.com.

Pump is not warrantied if dirt and debris is found in the check valves or pump.

Note: The air mixing motor must be oiled with two drops of an air oil daily. This air oil can be sourced from any local supplier of hand held air tools worldwide

MATEX FLUID INJECTOR